|
Cutter Table Maintenance
The table of a paper cutter requires periodic maintenance to remove surface oxidation. Polishing is also required to provide a smooth surface for paper to move freely.....
|
 |
|
|
|
|
|
|
Paper Cutting Guide
We have tried to compile the most common cutting material alphabetically. In order to make this list more clear, we have divided it in two groups. All values indicated in this list are based on our experience, which we have with high speed paper guilotines.
|
|
|
|
|
|
|
|
Paper Drilling Tips
Important! To prevent the drill from overheating, always avoid drilling too slowly. The table should be brought up as rapidly as possible allowing the drills to easily cut through the paper....
|
|
|
|
|
|
|
|
Knife Care Tips
Knife blade life, or the time between sharpenings, can be affected by many factors. One important factor is the type of paper being cut. Abrasive paper, such as recycled paper, soft paper such as newsprint paper, and bound books can all significantly shorten knife blade life....
|
|
|
|
|
|
|
|
BAUM Folder Impositions and their Setups
Reference pictures for the roll positions outlined in the common impositions, as well as the gapset positions.
|
|
|
|
|
|
|
|
Baum Floor Model Folders Job Setup
This sheet is only a guide to setup and operation of the Baum 2015/2018/2020 Pile feed folders. Jobs will vary and procedures will need to be modified.
|
|
|
|
|
|
|
|
Horizon SPF20 Threading Stitcher Head
This section shows how to thread wire to stitcher head.When you purchased a new stitcher head, put the mark with a same color on the stitcher head and former. This prevents the former from being installed to another stitcher head after removing it.
|
|
|
|
|
|
|
|
Interlake Threading Stitcher Head
Draw wire from the bottom of coil, and thread wire through slot at the end of wire guide, through wire guides and through upper wire straightener. NOTE - Make sure that wire is loaded on coil holder stud so that wire is fed counterclockwise from the bottom of coil.
|
|
|
|
|
|
|
|
Mitsubishi Silver DigiPlate - Technical Bulletin
SDP-FRS175 is compatible with virtually any polyester platesetter or laser imagesetter on the market today, and designed to work especially well in the Mitsubishi Eco1630 series and DPX series (including DPX 2, DPX 4 and DPX 4 Eco).
|
|
|
|
|
|
|
|
Mitsubishi XP printing without Appletalk
Windows XP does not contain the Appletalk network protocol so to print from Mac OS 9 and X an alternative, third-party software can be purchased from a software vendor that when installed on the rip computer will make the Appletalk protocol available on a Windows XP system.
|
|
|
|
|
|
|
|
Having problems
Having problems locating what you need. Plaese use the link to the right to request further information.
|
|
|
|
|
|
|
